locking collarの例文

• Once the cables were plugged to a receptacle, a twist of Ross'wrist moved a locking collar into place.
• Behne Machine Co . of York won a $ 36, 540 contract from the Navy in Mechanicsburg for locking collars.
• Once the cables were plugged to a receptacle, a twist of Ross'wrist moved a locking collar into place to prevent separation.
• Because of missing locking collars at two of the joints on the ammonia coolant lines, he was unable to attach pressure-relief clamps.
• The National Transportation Safety Board later reported that Walton had improperly reinstalled the rear locking collar on the elevator control torque tube.
• In 2000 the locking collar was modified slightly to allow the blade to be locked in the closed as well as the open position.
• It is possible to adjust the fitting of the safety locking collar in the event that the latter is either too tight or too loose.
• In 2009 Fisher designed an optional locking collar for use on the M1A SOOCOM rifle, which uses a different style of flash suppressor / muzzle brake.
• Due to the way in which the locking collar tapers, the blade does not loosen over time and can be fixed firmly even once the mechanism is quite worn.
• The locking collar ( " Virobloc " ) was patented in 1955 by Marcel Opinel, and is only found on the larger Opinel models ( # 6 and up ).
• A very few even choose to wear permanently locking collars ( these click into place and have no unlocking key ), that cannot be removed except by cutting the steel.
• The Mark 5's have a larger chamber to permit larger charges and a new liner with a heavier taper carbon steel along with a liner locking ring and locking collar.
• These features included a new baffle design, a shortened locking collar made from nitrocarburized stainless steel and revolver cylinder cuts on the coupler which allowed propellant gas to exit just forward of the locking collar.
• These features included a new baffle design, a shortened locking collar made from nitrocarburized stainless steel and revolver cylinder cuts on the coupler which allowed propellant gas to exit just forward of the locking collar.
• Mod 8 was the Mod 0 or Mod 4 also using a one-step conical liner, uniform twist rifling that was secured by a tube and liner locking ring with a liner locking collar at the breech end.
• After the mine has been armed, gradual pressure on the pressure plate ( i . e . when the victim steps on it ) rotates a locking collar until the striker is released, which flips into a stab-detonator and the mine explodes.
• The current Opinel knife consists of a blade, wooden handle, stainless steel metal clamping band, stainless pivot pin ( axle ), and ( except in the case of the smaller models ) a stainless steel " Virobloc " locking collar, which locks the blade open or closed.